Savant IP Audio Deployment Guide
Copyright © 2020 Savant Systems, LLC
009-1571-03 | 200224
7 of 39
3.4. Speaker Wiring
The PAV-SIPA1SM, PAV-SIPA50SM, and PAV-SIPA125SM use the same Speaker wiring. Speaker wiring is made using 4-pin Speaker Connectors
supplied with the IP Audio devices. The wire slips into the hole and locks with a screw located at the top of the connector. Speaker connectors
accept up to 12AWG speaker cable.
Pin 1
Right -
Pin 2
Right +
Pin 3
Left -
Pin 4
Left +
- R + - L +
4
3
2
1
NOTES
:
–
Wire order shown does not represent any wiring standard. It may be different than other models.
–
While not shown in the diagram above, Zones 2 to 4 follow the same wiring as Zone 1.
3.5. IR Wiring
The PAV-SIPA1SM, PAV-SIPA50SM, PAV-SIPA125SM, PAV-AIM7C, and IP-STUDIOxx all feature available ports for passing IR control to component
devices. Follow the diagram and notes below for the model of IP Audio device being installed to wire any IR control connections to component
devices.
IMPORTANT! IR Wiring Precautions
–
Ensure that all IR emitters are within 15 feet (4.6 meters) of the controller’s location.
–
Use of 3rd party flashing IR emitters with Talk Back is not recommended. These types of emitters can draw voltage away from the IR
signal, which may degrade IR control performance.
PAV-SIPA50SM
IR connections are made using 4-pin IR connectors supplied with
the device. The wire slips into the hole and locks with a screw
located at the top of the connector.
IR Pinout
Use white stripe
for positive (+)
4
3
2
1
Pin 1
IR 1 -
Pin 2
IR 1 +
Pin 3
IR 2 -
Pin 4
IR 2 +
- 1 + - 2 +
NOTE
: While not shown in the
diagram, IR connections 3 and 4
follow the same wiring as 1 and 2.
PAV-SIPA1SM / PAV-SIPA125SM /PAV-AIM7C / IP-STUDIOxx-2CH
IR connections are made using 6-pin IR Connectors supplied with the
device. The wire slips into the hole and locks with a screw located at the
top of the connector.
IR Pinout
Use white stripe
for positive (+)
4
3
2
1
Pin 1
IR 1 -
Pin 2
IR 1 +
Pin 3
IR 2 -
Pin 4
IR 2 +
- 1 + - 2 +
Pin 5
IR 3 -
Pin 6
IR 3 +
6
5
- 3 +
NOTE
: While not shown in the
diagram, IR connections 4 to 6
follow the same wiring as 1 to 3.