22
TOP OUTLET FLUE ASSEMBLY
Top outlet flue - Kit 85089
The boiler is supplied for rear outlet flue connec-
tion. For a top outlet flue :
●
Unscrew and remove the four screws and cir-
cular blanking plate from the top of the boiler.
●
From rear of boiler, unscrew and remove four
screws securing flue elbow clamps (
J
) to the rear
outlet.
●
Remove straight flue connector (
K
), plastic
adaptor (
L
) and angled connector (
M
) and dis-
card, see
diagram 43
.
●
Fit circular blanking plate, previously removed
from top of boiler, onto rear outlet of boiler.
●
Disconnect power supply and earth leads from
fan motor. Unscrew and remove the two fan re-
taining screws, see
diagram 44
.
●
Remove fan assembly from boiler.
●
Unscrew and remove the three screws holding
fan to mounting plate. Turn the fan body through
90 degrees in relation to the mounting plate to
leave fan outlet pointing upward.
●
Using the alternative set of three holes in the
mounting plate, fasten the fan to the mounting
plate, see
diagram 45
.
●
Disconnect air pressure switch tube from rear
pressure tapping point and connect to pressure
tapping point at top of boiler.
●
Refit fan assembly into boiler.
●
Fit the two retaining lugs at the back edge of
fan mounting plate onto back edge of flue hood
opening and bring fan mounting plate up against
flue hood.
●
Refit the two fixing screws.
●
Reconnect power supply and earth leads to fan,
the polarity is not important.
To fit the flue proceed as follows :
The flue
kit 85089
, see
diagram 46
, is 750 mm long
and comprises:
- Outer pipe ...........................................................
N
- Inner pipe ...........................................................
O
- External rubber sealing collar. ...........................
P
- Plastic flange ......................................................
Q
- Clamp and seal ..................................................
R
- Gasket .................................................................
S
- 2 ‘O’ rings .............................................................
T
- 4 screws ...............................................................
U
- Elbow ...................................................................
V
Cutting the flue hole
Follow the procedure described in the instructions
for the rear outlet flue.
Diagram 45
Diagram 44
K
M
L
J
Diagram 46
R
T
S
N
Q
O
P
U
V
Pho 025
Pho 032
Diagram 43
Pho 034
Pho 088
