12
OK
ON OFF
INSTALLATION OF THE CONTROL MODULE, PUSH BUTTON AND THE THERMOSTAT:
180 mm
55 mm
150 mm
Distance
between
holes
5 mm
Locking
Affixing hole
40 mm
32 mm
46 mm
Wall
Thermostat
cover
Back nut
Locking screw
21 mm
32 mm
Thermostat
24 mm
24 mm
Back nut
ON - OFF switch
Led-light
The control module is factory sealed to
withstand use in the humidity of the steam
room. It can be installed directly against
the wall, fixed with suitable screws through
the two fixing holes and sealed in place
with silicone sealed. A hole should be drilled
in the wall to feed the control cable back to
the generator - this may be directly behind
the control or just below. This hole should
be silicone sealed against ingress of
moisture.
The decorative bezel in Chrome onr White
is designed to clip fit onto the control
housing. This bezel is removed with the
supplied tool. Using this tool lightly press
the locking pin in each of the 4 holes
around the perimeter whilst pulling the
frame away from the control body.
The push button has been factory
sealed to wisthstand the humidity of the
steam room. Dependent on the type of
wall the button is fitted by drilling a
suitable hole and either securing with
the back nut (acrylis walls) or setting into
position with silicone sealant (solid walls).
If necessary a surface mount box may
be used.
The thermostat should be fitted 170 cm above
floor level, ideally on the wall opposite the
door. Drill a suitable hole and secure thermostat
either with the locknut (acrylic walls) or by
setting in place with silicone sealant (solid walls)
Ensure that a good tight seal is made to avoid
ingress of moisture to the wall. The thermostat
is inserted into its decorative casing.
.
Locking
Locking
Locking
