11
Control Module functions
The steam is started from the control module by pressing the ON/OFF button. After this, the
temperature display will flash. The temperature may be set with the + and - buttons in 1
0
increments
from 25 °C min. and 50 °C max. When the desired temperature is displayed press the OK button to
set the bathing time. The display flashes and the time can be set with the + and - buttons in 1 minute
increments up to 90 minutes. Above this the display switches to hourly mode to max. 4 hours. The
display will than show full hours until countdown reaches 90 minutes, when the readout will revert
to minute mode.
Light control
Lights can be controlled with the control module button, when the led next to the button is lit.
Connectors LC1 and LC2 on the circuit board are for light control. External voltage is connected to
the circuit board at 24 V DC, which is connected to LC1. When the lights button is pressed, a
transistor on the circuit board transfers the voltage into LC2, which carries out the actual light unit
control.
PUSH BUTTON
Functions of the button
When started with the button, the generator will run for 30 minutes and the led above the button
will light. The time cycle is fixed at 30 minutes and the generator stops automatically. The
generator can be stopped at any time during the cycle by pressing the button and the led light will
switch off. The steam generator can then be re-started as and when desired.
NOTE!
When using this button control, the thermostat separate must
always
be fitted. The
thermostat will ensure that temperature in the steam room will not rise above 50 °C.
The two-stage control works in the pressure button version so that once the thermostat detects 50 °C
two of the heat elements will be switched off by a contactor. Once the temperature drops by one
degree, all the elements will be switched on again. If the temperature rises over 50 °C, all the
elements will be switched off.
Led light
ON - OFF switch
