11
8.
Apply power to the device. The button will blink continuously between green and amber to
indicate that the device is in factory reset state. If the device is not in its factory reset state
when it is initially powered up, it can be reset by pressing and holding the front panel button
for at least 10 seconds, until the button starts to blink continuously between green and
amber.
5.3
Commissioning
To complete the installation process, the SS9007 Mini CT Meter must be joined to an existing ZigBee
network. The following instructions apply specifically to networks based on the Saturn South ESBox
Ethernet-ZigBee Gateway device, however the process will be very similar when using third party
ZigBee coordinators.
1.
Set the site's ESBox to ‘Permit Joining’ mode using the LSSS button sequence on the button
on the back panel of the ESBox (see the SS9002 ESBox LT documentation for more
information). When Permit Joining mode is successfully enabled, the EBox's ZigBee LED will
blink green for 120 seconds. During this 120 second window devices may be joined to the
network by repeating step 2.
If this site is being commissioned for the first time it is recommended that a factory reset be
performed on the ESBox before activating the first device using the Factory Reset (LLLSS)
button sequence.
2.
Instruct the new Mini CT Meter to join the network by pressing and holding the front panel
button for 5 seconds and then releasing it. The button will glow solid green to indicate that
the device is scanning for available networks. The device will then spend up to 10 seconds
attempting to join the ZigBee network. If the device joins the network successfully, the
button will flash green for 6 seconds. If the device fails to join the network, the button will
flash amber for 6 seconds. Please see the Troubleshooting section for more information on
debugging connection issues.
When joining multiple devices, perform the Association Join button sequence on each device
in turn, rather than entering the sequence on multiple devices at once.
3.
If the device successfully joins the network, as indicated in step 2, verify that the device
appears as ‘connected’ in the out
-of-band secure ESCo web management interface, and that
it is reporting power metrics.
