Network Video Recorder
User Manual
Network Video Recorder
4.1. Unpacking Inspection:
When you receive a product, check it according to the packing list inside the box.
4.2. Installation Preparation:
Preparation
Prepare a Cross Screwdriver.
Steps
Remove the metal top cover by removing two screws from the sides of the cover.
Place the hard disks on a flat table and tighten the screws.
Connect the power and the data lines to the HDD.
Reinstall the metal top cover and tighten the screws.
Caution
Only use the HDD specified by the manufacturer.
The HDD will be formatted automatically during booting and it may cause data loss.
The total duration of video data saved is decided by the HDD‟s capability and the NVR‟s parameters
(recording setup, encoding setup). Please refer to 9.3.
4.3. Installation of the burner:
Preparing for Installation
You need a Phillips screwdriver.
The burner installation steps
Unscrew the screw on the side of the chassis and open the case cover.
Use a screwdriver to remove the bracket fixed in middle of the disk.
Open the front panel door and remove the baffle inside.
Connect the burner data cable and the power cord.
Fix the chassis cover.
Precautions
The installation of the built-in burner is only for specific DVR and affects disk space for installation and inter-
faces.
4.4. The Front Panel:
Description: The following figure shows a 16-channel embedded DVR front panel, please prevail in kind.
4. Installation
7
