Network Video Recorder
User Manual
Network Video Recorder
27
Enable P2P by clicking OPEN, and click OK to finish the device configuration.
“Enable”
：
Open or Close
“Device ID”
：
Each serial number Of devices are different, this cannot be modified.
“Password”
：
This is generated by the system, you can change it.
“Local Port”
：
Default is 3000, can be modified.
“State”
：
Check the connect status of the device and the server.
- Online
- Offline, cannot connect to Internet.
When it shows Offline, click [Ping] to check the connect status again.
Note: If the status still shows offline, please check the if the network light is on, and the device is connected
or not.
6.5. PTZ Configuration:
Confirm the connection of PTZ A,B lines in the DVR and PTZ.
[Channel] Select the channel.
[Protocol] Select a associated protocol (e.g. PELCOD)
[Address] Set address. Default: 1.
Note: this address has to correspond with dome address,
or the dome will not be controlled.
[Baud Rate] Select the baud rate. Default is 9600.
[Data Bits] default: 8
[Stop Bits] default: 1
[Parity] default: None
