PN 22541 REV B - 7 - 5/18
Install “Tank option PN 16538” and Vent pipe:
Install “Tank Option PN 14508” and Vent pipe:
20) Install seat lid PN 10570 (comes with
plastic bolts & nuts) on tank PN 16538.
Plastic bolt through seat lid hinge into the
tank Thread plastic nut on bolt from inside
of tank. Position tank in left rear corner of
unit.
21) Hold tank against panel while installing
screws (3) PN 13860 from outside of unit in
dimples in left panel shown below using 3/8"
(.375”) [9.53 mm] Hex Driver bit.
22) Insert vent pipe PN 13796
into tank PN 16538 until it
bottoms out against screw.
23) Drive fourth screw PN 13860 through
rear panel into dimple in finger groove into
tank and vent pipe
using 3/8" (.375”) [9.53
mm] Hex Driver bit.
24) Drive fifth screw PN 13860
through rear panel into tank.
25) Drive fifth screw through rear panel into
tank. In line with dimple & up from dimple as
shown in rear panel
using 3/8" (.375”) [9.53
mm] Hex Driver bit.
26) Drive sixth screw through
“
X
“ rear panel centered
between dimples, as shown below. ( Right rear corner )
27) Note sixth screw through rear panel is centered between dimples
in far right rear corner as shown.