PN 22541 REV B - 15 - 5/18
Rivet Grab bar to left panel (from outside of unit):
65)
“Place Grab Bar on inside of left panel, make sure bottom of Grab
Bar is resting on vertical alignment ledges 2 per panel, sh
own above”
Outside of left panel
use (2) rivets PN 14427 in 2
horizontal “ᴑ” hole locations in rear panel through into 2 pre-drilled holes in Grab Bar. Then transfer drill into Grab Bar through
remaining (8) holes drilled in left panel using
#10 (.193”) [5 mm] Drill bit
(be careful not to drill through 2
nd
wall of Grab Bar)
.
Install (3) rivets PN 14427 with (3) washers PN 11360 in remaining 3 upper holes in rear panel into Grab bar. Install (5) rivets PN
14427 in 5 lower holes in left panel into Grab Bar as shown below.
2 pre-drilled ho
les in top of Grab Bar are in line with 2 horizontal “ᴑ” holes noted in left panel.
2530 Xenium Lane North, Minneapolis, MN 55441
Telephone: 763-553-1900 Fax: 763-553-1905
800-328-3332 / www.satelliteindustries.co
2 left panel
horizontal
“ᴑ”
locations to install
rivets in 2 pre-
drilled holes in top
of Grab bar
3 rivets PN 14427 with washers PN 11360
in top of grab bar
5 left panel lower
dimple locations to
install rivets in
bottom of Grab bar
