SATELLINE-EASy / SATELLINE-EASy 869
User Guide, Version 3.0
59
SL@P=nnnnn
Set RF output power (mW)
For example "SL@P=100" sets 100 mW transmitter output power.
Output power is rounded if given value does not match preset power levels.
Apart from other compilations, VAR2 accepts only "SL@P=#n" format command,
where n is [1...7] the number of the memory location in other words the wanted
power level of the transmitter output.
SL@R?
Get RSSI (Received Signal Strength Indication) of last received message (dBm)
SL@S?
Get radio compatibility mode
SL@S=x
Set radio compatibility mode. Value of x is:
0 = Satel 3AS
1 = Option 1 (PacCrest 4-FSK)
2 = Option 2 (PacCrest GMSK)
3 = Option 3 (TrimTalk GMSK) (Rx fits PacCrest modems)
4 = Option 4 (Trimtalk GMSK) (Rx fits Trimble modems)
5 = PacCrest-FST
SL@T?
Get current signal threshold (dBm)
Response: "-nnn dBm" (for example "-80 dBm" or "-112 dBm")
SL@T=-nnn
Set minimum power level of signal to be received (=Signal Threshold level)
Value of nnn is decimal value [80...118] in dBm
11.1.8
Other SL commands
Command
Effect and description of command
SL@X=n
Reset command. Values of n are:
"1" Reset BT (applies only to 3AS-OEM11)
"9" Reset modem
Response: "OK" or "ERROR", then modem resets required blocks.
SL+P=xxxx
Get measured signal strength from remote modem i.e. SL “ping”
Value of xxxx [0000...ffff] defines address of remote modem
Response: "OK" followed by RSSI info from remote modem
SL+T?
Get status of Transmitter tests
Response: "0" = Transmitter tests are OFF
"1" = Carrier test is ON
"2" = Deviation test is ON
SL+T=x
Activate/Stop transmitter test.
"0" = Stop any transmitter test
"1" = Transmit Carrier test
"2" = Transmit Deviation test
SL+W=xxx,n
Set transmitter output power level xxx [000...255] in memory location n [1...7]
0 sets the maximum power and 255 sets the minimum power
