SATELLINE-EASy / SATELLINE-EASy 869
User Guide, Version 3.0
43
9
PROGRAMMING MODE MENU
9.1
Programming Mode
The modem needs to be in the
Programming mode
before the
Programming mode menu
activates. The radio modem will shift into the
Programming Mode
by connecting the D15
connector pin 12 to ground (GND) potential. The radio modem will output a menu similar to
the example below. Independent from the configuration, the radio modem uses then the serial
interface PORT1 with settings 9600 bps, No parity, 8 data bits, 1 stop bit.
The recommended setup for using the
Programming mode menu
is NARS-1F adapter, CRS-9
serial/power cable, power supply and SaTerm software. Other suitable terminal programs and
cables may also be used. The
Programming mode
can be easily activated the by moving the
slide switch in NARS-1F adapter downwards.
----------------------------------------------------------------------------
***** SATELLINE *****
FW: 06.16.3.xx.xx / HW: SPL0005x / PV: 00.xx / IM: 01 / S/N: YYMMxxxx
----------------------------------------------------------------------------
Current settings
----------------
1) Radio frequency TX: 438.0000 MHz / RX: 438.0000 MHz /
Ref freq: 438.0000 MHz / Spacing 25 kHz
2) Radio settings Tx power 1000 mW / Signal threshold -115 dBm / FCS OFF /
TX start delay 0 ms / Compatibility Satel 3AS /
Call sign OFF / Channel List OFF
3) Addressing RX address OFF / TX address OFF /
RX address to RS port OFF / TX address autoswitch OFF
4) Serial port 1 ON / 9600 bit/s / 8 bit data / None parity /
1 stop bit
5) Serial port 2 OFF / 9600 bit/s / 8 bit data / None parity /
1 stop bit (RS-422)
6) Handshaking CTS Clear to send / CD RSSI-threshold /
RTS Ignored / Pause length 3 bytes
7) Additional setup Error correction OFF / Error check OFF / Repeater OFF /
SL-commands OFF / Priority TX / Full CRC16 check OFF /
User Data Whitening OFF / LCDWriteLock OFF /
Add RSSI to data OFF
/
Region Code Default
8) Routing OFF
9) Tests OFF
A) Restore factory settings
B) INFO
E) EXIT and save settings
Q) QUIT without saving
Enter selection >