INTEGRA Installer
Manual
3
1. Introduction
This manual covers the INTEGRA 24, INTEGRA 32, INTEGRA 64 and INTEGRA 128 control
panels. During installation, differences in technical parameters between particular main
boards should be taken into account
(see Table, page 5).
Devices incorporated in the INTEGRA alarm system meet requirements of the following
standards: 50131-3, 50130-4, 50130-5 and 50131-6.
2. General Features of Control Panels
The INTEGRA series alarm control panels are designed for small, medium-size and large
facilities. Irrespective of its dimensions, each of the control panels has identical, advanced
functional capabilities. The alarm systems which are based on them can be without difficulty
extended by using the same expansion modules for all these control panels. It also makes
possible to easily replace the control panel with a bigger one, if it is required by development
of the system. Owing to such a solution, the optimal control panel can be selected for the
particular site. The INTEGRA alarm control panels not only guarantee a perfect protection of
the facility against burglary; they also offer advanced functions of access control and
automatic operation of a number of devices. At the same time, they are easy to operate and
user-friendly.
The control panels are characterized by the following features:
•
Firmware of the alarm control panel is stored in FLASH type non-volatile memory, so it can
be easily updated with no need for dismounting of the panel. It only requires connection of
the panel to the computer via RS-232 port and starting of the procedure of firmware
replacement.
•
Saving the control panel settings to FLASH memory. These data will be retained even if
the RAM memory backup battery is disconnected.
•
Possibility to divide the system into objects and 32 partitions (partition = group of zones).
The partitions may be controlled by the user, timers, control zones, or their status may be
dependent on the status of other partitions. It is possible to temporarily restrict the access
to partitions.
•
Possibility of system development by adding the expansion modules (the development
extent depending on the control panel size). Creation of a system based on modules
(including the wireless system controller of SATEL manufacture) installed at various places
throughout the facility can considerably reduce the amount of cabling used.
•
Possibility to store in the system from 16 to 240 passwords (codes), which may be either
assigned to users or to control functions.
•
Variety of means for security system control:
−
LCD
keypad,
−
partition
keypad,
−
proximity cards reader,
−
433 MHz remote key fob (optionally, with INT-RX module installed),
−
868 MHz remote key fob (optionally, with ACU-100 controller, with firmware in version
2.0 or later, connected),
−
computer
with
D
LOAD
X
or G
UARD
X program installed,
−
SMS message (optionally, with GSM-4S module connected),
−
web browser (optionally, with ETHM-1 module connected),
−
mobile phone with MobileKPD application installed (optionally, with ETHM-1 module
connected),