Satel ASW-210, Manual

Page: 3 / 7

The ASW-210 controller enables 230 V AC wired devices to be remotely switched ON/OFF.
Additionally, the controller inputs make it possible to manually control these devices by using
wired switches. The controller is designed to work as part of the ABAX 2 / ABAX two-way
wireless system. This manual applies to the controller with firmware version 1.0, which is
supported by:

ABAX 2:
– ACU-220 / ACU-280 controller,
– ARU-200 repeater.

ABAX:
– ACU-120 / ACU-270 controller (firmware version 5.05 or newer),
– ARU-100 repeater (firmware version 2.02 or newer),
– INTEGRA 128-WRL control panel (firmware version 1.19 or newer and firmware
version of processor used to operate ABAX system 3.11 or newer).
1. Features

2 programmable relay outputs (which can be controlled by using the monostable or
bistable switch).

Galvanic isolation of the controller outputs.

2 programmable wired inputs (support for NO or NC type switches).

Encrypted two-way radio communication in the 868 MHz frequency band (AES standard
for the ABAX 2 system).

Transmission channel diversity – 4 channels for automatic selection of the one that will
enable transmission without interference with other signals in the 868 MHz frequency
band (ABAX 2 system only).

Remote update of detector firmware (ABAX 2 system only).

Remote configuration.

Mounted in in-wall and on-wall electrical junction boxes with a minimum diameter of
60 mm.
2. Specifications
Operating frequency band ...................................................................868.0 MHz ÷ 868.6 MHz
Radio communication range (in open area)
ABAX 2
ACU-220 .............................................................................................. up to 1000 m
ACU-280 .............................................................................................. up to 1000 m
ABAX.............................................................................................................. up to 500 m
Supply voltage ................................................................................. 230 V AC ±15%, 50-60 Hz
Standby current consumption .........................................................................................5.5 mA
Maximum current consumption........................................................................................13 mA
Rated switching voltage ..............................................................................................250 V AC
Relay outputs rated load – AC1 ......................................................................... 5 A / 250 V AC
Minimum switching current ..............................................................................................10 mA
Rated switching current ........................................................................................................5 A
Maximum breaking capacity – AC1 ............................................................................. 1250 VA