4 ASW-210
SATEL
6. Add the ASW-210 controller to the wireless system and configure its settings (see
ABAX 2 controller manual or INTEGRA 128-WRL control panel manual).
The sticker with
serial number which shall be entered when registering the detector in the system can be
found on the enclosure.
If the ABAX 2 / ABAX controller is connected to the VERSA / VERSA Plus / VERSA IP
control panel, use the DLOADX program to add and configure the ASW-210 controller.
Simultaneous operation of the ASW-210 controller by the ABAX 2 and ABAX controller
/ INTEGRA 128-WRL alarm control panel is not possible.
7. Close the junction box.
8. Check the level of radio signal received from ASW-210 controller by the ABAX 2 / ABAX
controller / control panel. If it is low, try to move around the ASW-210 controller and
check if it improves the signal strength. The controller can be installed in the selected
junction box if the signal strength is higher than 40%.
9. Power off the circuit to which the controller is connected.
10. Open the junction box and remove the controller.
11. Connect the wires of controller relay outputs to the wires of electrical circuits to be
controlled by the controller (Fig. 2).
Given the specific character of radio communication, it is not recommended that the
controller be used in applications where quick switching of the output status is
expected.
12. Connect switches to the controller inputs (Fig. 2). To make connections, use flexible
wires with a cross-sectional area of 0.5-0.75 mm
2
.
13. Mount the controller in the junction box. Make sure the electric wires are behind the
controller enclosure.
14. Close the junction box.
15. Power on the circuit to which the controller is connected.
16. Check the controller for proper functioning.
Summary of Contents for ASW-210
Page 7: ...SATEL ASW 210 5 ...
