SATEL ACU-250
11
4. The device will be removed. A message on the display will inform you that the expander
identification function has been started.
f wireless devices will follow.
5. After identification of the devices, return to the list o
7.2 Work with the VERSA control panels
The VERSA control panels can support up to 30 wireless devices. For information about
operation of the ABAX system controller with the VERSA control panels, as well as adding
ler manual of VERSA control panels.
and removing wireless devices, please refer to the instal
8. Programming the wireless devices
8.1 Parameters and options
Fi
s of communication with the device to be
po
n
lter
– the number of consecutive response periods, during which communication with the
device failed to be established, for the los
rted. Values from the 0 to 50 range can be entered. Entering the digit 0 will disable
trol of the device presence in the system.
In the case of the AMD-103 magnetic contact, the presence check is performed in
a different way than for the other ABAX system devices. If the value program
re
co
med for
the F
ILTER
parameter differs from 0, the lack of presence will be reported if no
transmission from the AMD-103 magnetic contact is received within one hour.
AR
RU-100 repeaters can be registered in the
Al
option is available for the most of wireless detectors. If enabled, the
te
T
U
– parameter available for a wireless device, if the ARU-100 repeater is registered in the
controller (the controller is connected to the INTEGRA or INTEGRA Plus control panel). It
allows you to define whether the device is to communicate to the controller directly, or via
the selected ARU-100 repeater (several A
controller). The programming procedure is described in section P
ROGRAMMING IN THE
INTEGRA
/
INTEGRA
P
LUS
SYSTEM
(p. 12).
ways active
– the
ctor is permanently switched over to the active mode (see section W
IRELESS
ECTORS
p. 15).
de
DE
The A
LWAYS ACTIVE
option need not be enabled for the wireless detectors assigned to
the 24-hour zones and for the AMD-103 detector.
Co
an be configured by radio (shown in square brackets is information on the zone for
more than 1
AG
ireless glass-break detector. Sensitivity is to be programmed.
ct with input for roller shutter detector. The following is
ch [first zone];
er shutter
nd zone].
nfiguration
– some of the wireless devices provide additional parameters and options,
which c
which additional parameters can be programmed, if the device takes up
zone):
D-100
– w
AMD-100
/
AMD-101
– wireless magnetic contact. The active reed switch is to be
selected.
AMD-102
– wireless magnetic conta
to be programmed:
active reed swit
number of pulses after which alarm will be triggered by the roller shutter input
[second zone];
time during which the specified number of pulses must occur for the roll
input to trigger alarm [seco
