SATEL
ACCO-KP2
12
5.1.4 Audible signaling
1 short beep
– access granted and door unlocked.
2 short beeps
– door blocked, unblocked or restored to normal mode.
3 short beeps
– waiting for the second identifier to be used.
1 long beep
– access denied (known card or code). The user cannot unlock the door
because:
the keypad only grants access based on the code, but the card has been used,
the keypad only grants access based on the card, but the code has been entered.
2 long beeps
– access denied (card or code unknown).
3 long beeps
[after you present the card / enter the code and press
]
– access denied
(known card or code). The user cannot unlock the door because:
the user is not authorized to unlock the door according to the access schedule,
the door is blocked,
the user exceeded the defined limit of entries,
the user tries again to enter or exit
– the “Anti Passback” option is enabled,
the module operates in the mantrap / airlock configuration and the other door is open.
3 long beeps
[after you hold the card / enter the code and press
]
– impossible to change
the door status (block / unblock / restore to normal mode), because the door status is not
controlled.
1 very long beep
– access denied (the keypad is blocked by the “Anti-Scanner” function).
Long beep lasting 10 seconds
– alarm.
5.2 Unlocking the door
The door will unlock when you are granted access. When the door is unlocked, you will be
able to open the door. The installer should tell you how much time you have to open the door
after access is granted and how much time you have to close the door. The installer should
also tell you which of the following procedures to use in order to get access.
If alarm memory is signaled in the keypad (the
LED is flashing), the alarm memory
will be cleared as soon as the user with the
“Administrator” right is granted access.
5.2.1 Getting access
Getting access by using the code
1. Enter the code and press
.
2. When the
LED will start flashing, open the door.
Getting access by using the proximity card
1. Present the card on the keypad reader.
2. When the
LED will start flashing, open the door.
Getting access by using two identifiers
1. Use the first identifier.
2. When 3 short beeps signal that the keypad is waiting for the second identifier
– use the
second identifier.
3. When the
LED will start flashing, open the door.
