SATALARM SA-612 & SA-816 installer manual ver 1.1
4. Master User’s Programming Menus
While the system is partially armed,
in order to enter the main programming menu allowed only to the “master user”
enter one of the [*][7][Master Code]
or
[CODE][Master Code] commands,
Where *CODE+ is the key labeled “CODE”
Once this procedure was initialized by entering [*] or [CODE] key, all the keypad LEDs will turn OFF.
After entering the
“
master code
”,
the keypad buzzer will sound 3 beeps
,
confirming the
system is being within “master user’s programming
menu”.
While the system is being within
“master user’s programming menu”, the keypad LEDs’ status will be
as follows:
ARMED A LED
ON
SYSTEM LED
Blinking
READY LED
OFF
Zone LEDs
OFF
Note: The “master user’s programming menu” can be exited by *#+ key pressing.
When exiting the “master user’s programming menu”, the system will go
back within disarmed status and the keypad LEDs will display the system and zone status.
There are several “master user’s submenus” where the “master user” can perform the following operations:
1.
Selective Programming/Erasure of 01 to 45 user codes
(“master user’s submenus” from *001+ to *045+);
2.
Simultaneous Erasure of all user codes
, except the “
master code
” (“master user’s submenu” *049+);
3.
Selective Programming/Erasure of the follow me phone numbers
(“master user’s submenus” from *051+ to *054+);
4.
Simultaneous Erasure of all follow me phone numbers
(“master user’s submenu” *050+);
5.
Programming session of the system time and date
(“master user’s submenu” *060+).
6.
“Ambush Digit Programming”
(“master user’s submenu” *061+).
While the system is being within
“master user’s programming menu”,
in order to program the 01 to 45 user codes, the
“follow-me” phone numbers, the system time and date or the “ambush digit”, select one of the *001+ to *045], [049], [050],
*051+ to *054+, *060+ or *061+ “master user’s submenus”
.
To enter each “master user’s submenu” the master user should enter 3
digits which are corresponding to the order number of each submenu (i.e. for submenu no. 9 press [00] and [9] keys).
After entering the 3 digits corresponding to the order number of one submenu, the keypad buzzer will beep for 3 times,
confirming the system is being within respective submenu.
Once the system was entering one of the “master user’s submenus”, the keypad LEDs’ status will be as follows:
Keypad LEDs:
LEDs’ Status:
Remarks:
ARMED A LED
ON
SYSTEM LED
Blinking
READY LED
ON
zone 1, 2 and 3 LEDs
Blinking
That means the selected user code, the follow me phone number or the system time and date
were
programmed
during a previous programming session.
only zone 1 LED
Blinking
That means the selected user code, the follow me phone number or the system time and date
are not
programmed
and
the control panel is waiting for first digit group
for respective option.