133
EN
Operating instructions
SATAjet K 1800 spray mix
Operating instructions
SATAjet K 1800 spray mix
er
[8-2]
.
■
Pull the bolt
[8-4]
out of the gun body and trigger guard
[8-3]
.
■
Remove the trigger guard
[8-3]
.
Mount new trigger guard
■
Position the trigger guard
[8-3]
on the gun body.
■
Push the bolt
[8-4]
into the trigger guard and gun body in the correct
position. The flat side of the bolt must point downwards.
■
Push the washer
[8-2]
onto the bolt.
■
Tighten the fastening screw
[8-1]
on the bolt.
10.3. Replace the paint needle seal
This must be replaced when material leaks from the self-adjusting paint
needle seal.
Remove packing screw
■
Carry out the steps to dismantle the material nozzle „Dismantle the
pre-nozzle, paint needle and paint needle tappet“ (see chapter 10.1
).
■ Unscrew the sealing screw (spanner size 6)
[9-1]
.
■
Remove both seals
[9-2]
from the gun body.
■
Dispose of the seals.
■
Check sealing screw for damage and soiling, clean or replace if neces-
sary.
Mount the new sealing screw
■
Insert new seals
[9-2]
in the gun body, heeding the installation direction.
■
Tighten the sealing screw
[9-1]
to the maximum
■
Proceed with the steps to "Mount pre-nozzle, paint needle and paint
needle tappet" and "Mount material nozzle" (see chapter 10.1
).
10.4. Replacing spindles of round/flat fan control
Note!
The thread of the spindle is coated with Loctite 242 during installation.
Greater use of force is therefore necessary when dismantling.
Dismantle spindle
■ Unscrew the countersunk screw (TX 20)
[10-1]
.
■
Remove the control knob
[10-2]
.
■ Unscrew the spindle using a ring spanner (spanner size 12)
[10-3]
.
Mount new spindle
■
Secure the new spindle
[10-3]
with Loctite 242, screw into the gun body
Manual_SATAjet-K-1800-spray-mix 26-sprachig.indb 133
Manual_SATAjet-K-1800-spray-mix 26-sprachig.indb 133
29.10.2021 13:54:01
29.10.2021 13:54:01