SATA SATAjet 5000 B RP, Operating Instructions Manual

Page: 104 / 420

104
EN
Operating instructions SATAjet 5000 B RP/HVLP
7. Use
Warning! Risk of explosion!
• Use only solvent-resistant, antistatic, undamaged and technically
flawless compressed air hoses with a permanent pressure resistance
of minimum 10 bar, e.g. Art. No. 53090 !
Notice!
The following requirements must be fulfilled:
• Compressed air connection 1/4" male thread or a suitable SATA con-
nection nipple.
• Ensure minimum compressed air volume (air consumption) and pres -
sure (recommended spray gun inlet pressure) according to chapter 2.
• Use clean compressed air, e.g. by installing the SATA filter 484, Art.
No. 92320
• Use an air hose with minimum 9 mm inner diameter (see warnings),
e.g. Art. No. 53090.
1. Check if all screws [2-1], [2-2], [2-3], [2-4] and [2-5] have been
tightened firmly. Tighten fluid tip [2-1] firmly by hand (14 Nm) accord -
ing to [7-4] . Check if locking screw [2-5] has been firmly tightened
according to [10-1] . Tighten, if necessary.
2. Rinse material passages with suitable cleaning solution [2-6] , ob-
serve chapter 8.
3. Adjust air cap: vertical spray fan [2-7] , horizontal spray fan [2-8] .
4. Insert paint strainer [2-9] and install gravity flow cup [2-10] .
5. Fill gravity flow cup (max. 20 mm below upper edge), close with the lid
[2-11] and insert anti-drip device [2-12] .
6. Screw connection nipple [2-13] (not included in delivery) onto the air
inlet.
7. Connect compressed air hose [2-14] .