SAS900MTK-0
A0
14
4.
Select filter replacement run time
The thermostat will display the Filter Alarm after a set time of operation. This is a reminder
to change or clean your air filter. This time can be set from 00 to 12 months in 1 month
increments. Selection of 00 WILL CANCEL THIS FEATURE. When Filter Alarm is displayed,
you can clear it by pressing the "
" button (To enter filter program) and then hold the ▲
and ▼ buttons. This resets the timer and starts counting the days until the next filter change.
The default setting is “00”.
5.
Select ºF or ºC readout
Changes the display readout to Centigrade or Fahrenheit as required. The default setting is
“F”.
6.
Select temperature recalibration
This feature allows you to adjust the displayed room temperature up to 4º higher or lower.
Your thermostat can be accurately calibrated to match your previous thermostat. The
current or adjusted room temperature will be displayed on the display. The default setting is
“0”.
7.
Select compressor lockout delay
To protect the compressor from short cycling, you can select compressor off-time cycle
between 0 or 5 minutes. When the thermostat compressor time delay
occurs,
the
Cool
On or Heat On display will flash during compressor lockout.
The default setting is “5”.