- 11 -
7.
Select display backlight
The display backlight improves display contrast in low lighting conditions.
Select 1
for NO backlight display.
Select 2
for the backlight to come on for approximately 30 seconds
when any button of the thermostat is touched.
Select 3
for the backlight to remain on continuously.
NOTE: When operated from batteries (No “C” terminal connection, or if AC power goes off), the
LCD continuously display of backlight will be disabled.)
12. Select temperature recalibration
This feature allows you to adjust the displayed room temperature up to 4º higher or lower. Your
thermostat can be accurately calibrated to match your previous thermostat. The current or adjusted room
temperature will be displayed on the display.
13. Select ºF or ºC readout
Changes the display readout to Centigrade or Fahrenheit as required.
14. Program options
7: Select 7-day program function for the thermostat
3: Select
5 weekday and 1Saturday and 1Sunday.
program function for the thermostat
0: Select non-program function for the thermostat
15. Select second stage heating rate
This option apply only to HP1, HP2, 2H setting in system type option
Second stage heating rate. Second stage heating will activate H2sp below first stage heating
16: Select second stage cooling rate
This option apply only to HP2, 2H setting in system type option
Second stage cooling rate. Second stage cooling will activate C2sp above first stage cooling
17. Select filter replacement run time
The thermostat will display the
“Chg Filter”
after a set time of operation. This is a reminder to
change or clean your air filter. This time can be set from 0 to 12 months in 1 month increments. Selection
of
00
WILL CANCEL THIS FEATURE. You can check the count back time and clear it by following step
1.
Press
MENU
button for displaying main button
2.
Press
OTHER
button for displaying other button
3.
Press
INFO
to inquiry for the count back change filter time
4.
When
“Chg Filter”
is displayed,
RESET
button will be shown when inquiry for count back time.
Press
RESET
and then press
DOWN
to reset the timer. This resets the timer and starts counting the
hours until the next filter change.
18. Select UV lamp replacement run time
This is the reminder to change UV lamp. Select UF means you have canceled the feature. Select UO
starts to counting for 0 day to 400 day. The thermostat will display “
Chg UV
” when
UV time (400 days)
Summary of Contents for SAS6000UTK-7
Page 20: ...20...
