Sartorius LP Models, Operating Instructions Manual

Page: 31 / 99

31
Operating the Balance
Application Programs
Using Verified Balances as Legal
Measuring Instruments in the EU*:
All application programs can
be selected on balances used as
legal measuring instruments.
Calculated values can be indicated
as follows:
Percent = %
Piece count (counting) = pcs
Computed value = o, G
Toggle between Weight Units
Purpose
With this application program
you can switch the display
of a weight value back and forth
between two weight units by
pressing a soft key.
Available Features
– Toggling the displayed weight
– Setting the display accuracy
– Other features as for the basic
weighing function
Factory Settings
Weight unit 1: Grams/g (
1 7 2
)
Display accuracy 1 (in the 1st
range): All digits (
1 8 1
)
Weight unit 2: Grams/g (
3 1 2
)
Display accuracy 2 (in the 2nd
range): All digits (
3 2 1
)
Preparation
The following weight units are available in both ranges:
Unit Conversion factor Display Printout
Grams 1.00000000000 g g
Kilograms 0.00100000000 kg kg
Carats** 5.00000000000 ct ct
Pounds** 0.00220462260 lb lb
Ounces** 0.03527396200 oz oz
Troy ounces** 0.03215074700 ozt ozt
Hong Kong taels** 0.02671725000 tl tlh
Singapore taels** 0.02645544638 tl tls
Taiwanese taels** 0.02666666000 tl tlt
Grains** 15.43235835000 GN GN
Pennyweights** 0.64301493100 dwt dwt
Milligrams** 1000.00000000000 mg mg
Parts per pound** 1.12876677120 o /lb
Chinese taels** 0.02645547175 tl tlc
Mommes** 0.26670000000 o mom
Austrian carats** 5.00000000000 o K
Tola** 0.08573333810 o tol
Baht** 0.06578947436 o bat
Mesghal** 0.21700000000 o MS
Setting Weight Unit 1
● Access the Setup menu:
select
Menu
● Set the parameter for weight
unit 1 (
1 7 2
through
1 7 20
):
See “Configuring the Balance”
● Set display accuracy 1
(
1 8 1
through
1 8 5
) :
See “Configuring the Balance”
Setting Weight Unit 2
k
Access Setup: select
Menu
● Set the parameter for weight
unit 2 (
3 1 2
through
3 1 20
):
See “Configuring the Balance”
●
Set display accuracy 2 (
3 2 1
through
3 2 5
):
See “Configuring the Balance“
● Exit the Setup menu: Press
M
The following levels of display
accuracy are available in both
ranges:
– All digits
– Fewer for weight change
– Last digit off (reduced by 1 digit)
● Turn on the balance: Press
e
> All segments of the display light
up briefly
● Configure the “Toggle between
Weight Units” application in the
Setup menu: Press
M
● Select the configuration mode:
Press
w (
menu
soft key)
● Set the parameter
2 1 2
: See
the chapter entitled “Configuring
the Balance”
● Exit the Setup menu: Press
M
* including the Signatories of
the Agreement on the European
Economic Area
** = not applicable in balances
verified for use in legal
metrology