Interface Port Input/Output
You can connect a checkweighing display
and a remote universal switch to the inter-
face port (factory setting).
When you connect a remote universal
switch, you need to change the following
parameters.
Printing an ISO/GLP-compliant Record
In the Setup menu, you can configure
whether
– no ISO/GLP-compliant record will be
printed (
off
,
8 10 1
),
– an ISO/GLP-compliant record will be
printed after calibration/adjustment
(
Only for cal./adj.
,
8 10 2
), or
– every printout will be an ISO/GLP-com-
pliant record (
always ON
,
8 10 3
)
Undoing All Parameter Changes –
Reset Function
There is a factory setting for each
parameter. In the Setup menu, you can
configure whether
– menu factory settings will be restored
after exiting Setup (
Restore
,
9 1 1
), or
– menu factory settings will not be resto-
red after exiting Setup
(
Do not restore
,
9 1 2
)
68
Pin Assignments for the Female Interface Connector
Pin
Input Function (
8 8 1
)
Output Function (
8 8 2
)
15
p
key
Remove universal switch (see below)
16
t
key
Control output port 1: lighter
17
q
key
Control output port 2: equal
18
v
key
Control output port 3: heavier
19
c
key
Control output port 4: “set”
Remote universal switch
Function
Menu setting
p
key
8 4 1
t
key
8 4 2
q
key
8 4 3
v
key
8 4 4
c
key
8 4 5
w
key
8 4 6
See “Pin Assignment Chart” in the chapter
entitled “Overview” for detailed informa-
tion.
