DQD 507 Rev. 2019-04-30
© 2018 CSA Group. All rights reserved.
Page 1
Certificate of Compliance
Certificate:
80000336
Master Contract:
167555
Project:
80000336
Date Issued:
2019-05-29
Issued To:
Sartorius Lab Instruments GmbH & Co. KG
Otto-Brenner-Strasse 20
Goettingen, Niedersachsen, 37079
Germany
The products listed below are eligible to bear the CSA Mark shown with
adjacent indicators 'C' and 'US' for Canada and US or with adjacent
indicator 'US' for US only or without either indicator for Canada only.
Issued by:
Eric Fortier
Eric Fortier
PRODUCTS
CLASS - C872106 - ELECTRICAL LABORATORY EQUIPMENT
CLASS - C872186 - ELECTRICAL LABORATORY EQUIPMENT Certified to US Standards
Digital scales, table top, portable, DC powered, Class III, models and rating as follow;
BCA Series; rated: 15Vdc, 6W max.
BCE, BCL, GL and GCL Series; rated: 15Vdc, 4W max
Units are powered via a certified external PS rated: Input: 100-240Vac, 50-60Hz, 0.2A, Output: 15Vdc, 0.53A
Notes:
1.
The above model is Equipment Class III (powered by an external Limited power source class II power
supply), Pollution Degree 2 and Overvoltage category II
2.
Mode of operation: Continuous
3.
Environmental Conditions: 5 to 40 °C, 3000 m. max, 80% rH max at 31°C down to 50% rH max at 40°C
Certificate:
80000336
Project:
80000336
Master Contract:
167555
Date Issued: 2019-05-29
DQD 507 Rev. 2019-04-30
© 2018 CSA Group. All rights reserved.
Page 2
CONDITIONS OF ACCEPTABILITY
(1)
Equipment is intended to be used with power supply FSP Group Inc, Model FSP008-P01N (Sartorius
model YEPS01-15V0W). The equipment can also be used with any other power supply approved for
Canada and USA under the 60950-1 or 61010-1 or equivalent standards and which provides Reinforced
insulation between mains and secondary circuits. It must be rated for 3000m and up to 40°C and must
provide an output of 15Vdc LPS (must comply with clauses 6.3 and 6.5 of 61010-1) with a minimum of
0.3A.
(2)
External Direct plug-in power supply was considered as the disconnect device.
(3)
For use in dry locations only.
(4)
No user replaceable battery. Internal lithium coin cell can only be replaced by Service personnel.
(5)
The display YSD01 is an accessory (no CSA label) for the scale and can be used as a remote (second)
display, which is connected to the scale via a USB cable.
APPLICABLE REQUIREMENTS
CAN/CSA-C22.2 No. 61010-1-12
- Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use, Part 1: General Requirements
UL Std. No. 61010-1 (3
rd
Edition)
- Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use - Part 1: General Requirements
Summary of Contents for Entris II Advanced BCA124-1S
Page 324: ......
