4
If the supply cord is damaged, it must be replaced by a qualified person in order to avoid
electrical hazard.
INSTALLING YOUR STEAK AGER
Unpack and remove all of the protection and adhesive strips from the packaging around and
inside the Steak Ager.
The Steak Ager must be positioned such that the plug is accessible. Release the power cord.
Move your Steak Ager to its final location. The Steak Ager should be installed in a suitable
place where the compressor will not be subject to physical contact.
Leveling your Steak Ager:
Steak Ager must be leveled BEFORE loading your Steak Ager.
Your Steak Ager is equipped with 4 adjustable feet to facilitate easy leveling. recommends
that you tighten the back feet to the maximum and adjust the front feet to level the Steak
Ager.
INSTALLATION INSTRUCTIONS FOR BUILT IN STEAK AGER:
FRONT VENTING STEAK AGER ONLY
.
1. “Built in” Steak Ager are front venting but are not designed to be fully integrated behind a
joinery door.
2. Please follow the installation diagram when installing built-in Steak Ager. No less than the
minimum installation dimension.
3. Built-in Steak Ager draw air from right of ventilation frame and expel through left of
ventilation frame under the front door.
4. “Built in” Steak Ager have a power switch located on the control panel so power point
location is not critical.
5. The Steak Ager requires a standard 240 volt/10 amp power point. (Or according to
different countries specifications).
6. The power cord is 2.0m in length and is fixed on the right side at the back when looking
from front of cabinet.
7. As with most appliances of today, the Steak Ager has sensitive electronic components
which are susceptible to damage through lightning and electricity supply faults. It is
therefore advised to use a power surge protector to avoid problems of this nature.