3
Attention:
When the Steak Ager is at “OFF” condition:
- Please take out all of goods from Steak Ager;
- Please keep Steak Ager clean
Allow 24 hours before switching on the Steak Ager. During this time we recommend
that you leave the door open to clear any residual odors.
BEFORE LOADING & PLUGGING IN THE STEAK AGER
Important: All models without front venting (air opening) are strictly for free standing
only. (See technical chart)
Recommendations:
The location you have selected for your Steak Ager should:
- be unencumbered and well ventilated;
- be well away from any heat source and direct sunlight;
- not be too damp (laundry, pantry, bathroom etc.);
- have a flat floor;
- have a standard and reliable electricity supply (standard socket to country standards,
linked to the ground), it is NOT recommended to use a multi-socket or extension lead;
- have a surge protector fitted to the electrical outlet;
- Away from the microwave oven. Certain microwave ovens do not have wave
interference shield. When placed within 1 meter vicinity of the Steak Ager, they may
affect the operation of the Steak Ager.
Notes:
- VI40SA ,VI85SA,VI110SA,VI116SA models are for free standing ONLY.
- VI46SA, VI60SA, VI88SA, VI120SA, VI180SA models are Both built-in and free-
standing type as per the drawings thereafter.
Steak Ager should be install at suitable ambient temperature (please refer the end of User
Manual). If the temperature is higher or lower the ambient temperature range, it will affect
temperature fluctuation and can’t reach cooling performance.
Grounding instructions:
The Steak Ager must be grounded in case of wire leakage. Grounding reduces the risk of
electrical shock. The Steak Ager is equipped with a power cord having a grounding wire and
plug. The Steak Ager plug must be plugged into a properly affixed and grounded electrical
outlet.
Note:
In locations where there is frequent lightning, it is advisable to use surge protectors.
Improper use of the grounding plug can result in the risk of electric shock. Consult a
qualified electrician or service person if the grounding instructions are not completely
understood.