EC700 Power Control System
Issue: 1
Page 6 of 17
1
st
October 2017
Leisure battery
– when selected the button is back lit blue, when not selected the button is
back lit grey.
Vehicle battery
– when selected the button is back lit blue, when not selected the button is
back lit grey.
Smart battery charging
– smart charging monitors the leisure and vehicle battery voltages
and automatically changes the battery being charged to ensure both batteries are optimally
charged. When selected the button is back lit blue, when not selected the button is back lit
grey.
Tank Fill
– pressing this start the automatic filling of the fresh water tank, the filling process
will automatically stop when the tank sensors detect it is full or after 7 minutes of filling
whichever occurs sooner. The button will be back lit blue while filling.
Tank Heaters
– This button will be back lit blue when active. This doesn’t mean that the tank
heaters will be switched on. The tank heaters will only be on while the external temperature is
below 2
o
C and if there is over 25% of water in the tank.
Active battery select
– The battery highlighted in blue is the active battery, this is the battery being
charged by mains (when plugged in) and the battery that is being used by the system. Pressing the
smart battery charging button switches smart charging on and off, the button is lit blue while on.
Solar battery select
– the battery highlighted in blue is the battery that the solar charging is being
directed too. Pressing the smart battery charging button switches the solar smart charging on and off,
the button is lit blue while on.
2.5.5 Lighting settings screen
Lights to be automatically be switched on with power:
On the left side of the screen the lights to be switch on with the power button are shown.
Pressing the toggle button next to each selects which lights will be switch on when the power button is
pressed from off to on.
Set dimming level:
In addition to holding the dimmed lights button the dimming level can be adjusted in 5% steps by
pressing the ‘–’ button to reduce the lighting level and the ‘+’ button to increase the lighting level.
