The Sapling Company, Inc.
1633 Republic Road
Huntingdon Valley, PA 19006
215.322.6063 P.
215.322.8498 F.
www.sapling-inc.com
7
q
Separate the front of the clock from the back case -
Locate the four (4) tabs (two (2) on the left side and two (2) on the right side of
the clock) and disengage those tabs by pressing down on them with a flathead screw driver no further than 1/4 inch. This will allow the front
of the clock to separate from the back case section of the clock. The back case is the portion that will be mounted to the wall first. Make
sure that both the clock and the back case are facing in the upright position before moving on to the next steps.
w
Screw the mounting cap to the switch box or wall -
Line up the upper keyhole style mounting point on the mounting cap with the
upper hole on the switch box and screw it in using one (1) of the 6-32/1” screws supplied in the kit.
Note: with this mounting option,
the installer cannot mount to a double switch box. In this option, the installer may only mount to a single switch box
only using the upper keyhole mounting point, or use both the upper and lower keyhole mounting point and only mount
directly to the wall.
Note: if the installer wishes to secure the clock in a vertical position when mounting to a switch box, there is
a hole located on the bottom/center of the back case for an anchor screw (anchor and anchor screws not provided
in kit). This should be completed before Step 3. Before installing the achor, line the back case up with the mounting clip
withouthanging it and make the mark on the wall where the hole on the bottom/center of the back case is. Tap into that
mark on the wall to install the anchor. After step 3 is completed and the back case is hung on the mounting cap, drive a
screw into the bottom center hole of the back case where the anchor is located in the wall.
e
Hang the back case on the mounting cap-
Take the back case that was originally separated from the front of the clock in step 1 and
feed the wiring coming from the switch box and the hole in the mounting cap and feed it through the corresponding hole in the back case.
r
Insert batteries -
Take the front of the clock and locate the battery pack attached to the movement. Pop off the cover and insert two (2)
D-cell batteries (Sapling recommends the use of Duracell Procell). After the batteries are secured, the clock should begin to find the correct
time. Snap the battery cover back over the battery pack.
t
Attach the front of the clock to the back case -
With the batteries now installed and the clock begining to operate, take the front
of the clock and snap it back together with the back case. Press the front of the clock into the back case, making sure the tabs that were
disengaged in step one are properly snapped back together.
Note: when pressing the front of the clock onto the back case, DO
NOT press on the center of the clock. Rather, push on the outer edges of the frame of the clock as to not damage the
contents of the clock.
Wall Mount Installation Square Clock (wireless, battery operated applications)
