14
OPERATION WITHOUT THE
REMOTE CONTROL UNIT
If you have lost the remote control unit or it has trouble, follow the
steps below.
When the air conditioner is not running
Each time the OPERATION button is pressed with a small pointed
tool, the operation mode changes cyclically, by changing the color
of the OPERATION lamp.
The temperature is set to the room temperature minus 2°C during
the cooling operation and to the room temperature plus 2°C during
the heating operation, and the fan speed and flap are set to Auto.
For normal operation, do not set to TEST, which is used only
for servicing the air conditioner.
CARE AND CLEANING
Casing and Grille (Indoor Unit)
Clean the casing and grille of the indoor unit with a vacuum
cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with a mild
liquid detergent. When cleaning the grille, be careful not to force
the vanes out of place.
Removing the front panel
• Push the front panel all the way upward.
Pull while supporting the nearest point of the arms toward you.
• Remove the sub grill attached to the rear of the front panel after
setting the four levers to loosen.
•
Washing the front panel with water
• Clean the front panel gently using a soft sponge, or the like. Then
wipe away any remaining moisture.
• Neutral detergent may be used to remove stubborn dirt. Then
rinse thoroughly with water and wipe away any remaining
moisture.
Remounting the front panel
• Reattach the subgrille onto the front panel then tighten the four
levers.
• Support the nearest point of the front panel keeping it horizontal
then push arm axis to the grooves at the top of the indoor unit.
• Press the locations marked by the arrows and close the front
panel.
How to remove the anti-mold filter
1.
Open the front panel until it is nearly horizontal, grasp the
sections near the front panel arms on both sides, and then pull
toward you to remove the front panel.
2.
Remove the anti-mold filter.
Cleaning
Use a vacuum cleaner to remove light dust. If there is sticky dust
on the filter, wash the filter in lukewarm, soapy water, rinse it in
clean water, and dry it.
1.
For safety, be sure to turn the air
conditioner off and also to
disconnect the power before
cleaning.
2.
Do not pour water on the indoor unit
to clean it. This will damage the
internal components and cause an
electric shock hazard.
1.
Never use solvents, or harsh
chemicals when cleaning the indoor
unit. Do not wipe the plastic casing
using very hot water.
2.
Some metal edges and the fins are
sharp and may cause injury if
handled improperly; be especially
careful when you clean these parts.
3.
The internal coil and other
components of the outdoor unit
must be cleaned every year. Consult
your dealer or service center.
OPERATION button
INDOOR UNIT
TEST button
OPERATION lamp
Cooling operation
(green)
Heating
operation (red)
Stop
(lamp off)
NOTE
CAUTION
CAUTION
Loosen
Tighten
Tighten
Loosen
Lever
Front panel
Sub grille
Lever
Arm
Front panel
Groove
Front panel
Arm shaft
Arm
CAUTION
When using a footstool or the like, be
careful not to let it tip over.
Front panel
Air clean filter
Anti-mold filter
Arm
OI-925-14-EG
01_SAP-KRV96EHDS_EN.fm Page 14 Wednesday, January 17, 2007 9:51 AM
