Sanyo PLC-XU88W, Owner'S Manual

Page: 18 / 78

17
Installation
Installation
Connecting the AC Power Cord
This projector uses nominal input voltages of 100-120 V or
200–240 V AC and it automatically selects the correct input
voltage. It is designed to work with single-phase power
systems having a grounded neutral conductor. To reduce
the risk of electrical shock, do not plug into any other type of
power system.
If you are not sure of the type of power being supplied,
consult your authorized dealer or service station.
Connect the projector with all peripheral equipment before
turning the projector on.

Notes:
Unplug the AC power cord when the projector is not in
use. When this projector is connected to an outlet with the
AC power cord, it is in Stand-by mode and consumes a
little electric power.
Connect the AC power cord (supplied) to the
projector.
To the AC outlet.
(200 - 240 V AC)
NOTE ON THE POWER CORD
AC power cord must meet requirement of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If supplied AC power cord does not match your AC outlet, contact your sales dealer.
To power cord
connector on your
projector.
Projector side AC outlet side
Ground
To the AC outlet.
(120 V AC)
For the U.S.A. and Canada
To the AC outlet.
(200 - 240 V AC)
For the U.K. For Continental Europe
CAUTION
The AC outlet must be near this equipment and must be
easily accessible.