Sanyo PLC-XU116, Service Manual

Page: 8 / 120

-8-
Maintenance
Cleaning the Projector Cabinet
Cleaning the Projection Lens
Unplug the AC power cord before cleaning.
Gently wipe the projection lens with a cleaning cloth that
contains a small amount of non-abrasive camera lens
cleaner, or use a lens cleaning paper or commercially
available air blower to clean the lens.
Avoid using an excessive amount of cleaner. Abrasive
cleaners, solvents, or other harsh chemicals might scratch
the surface of the lens.
Unplug the AC power cord before cleaning.
Gently wipe the projector body with a soft dry cleaning cloth.
When the cabinet is heavily soiled, use a small amount of
mild detergent and finish with a soft dry cleaning cloth. Avoid
using an excessive amount of cleaner. Abrasive cleaners,
solvents, or other harsh chemicals might scratch the surface
of the cabinet.
When the projector is not in use, put the projector in an
appropriate carrying case to protect it from dust and
scratches.
When moving this projector or while not using it over an
extended period of time, replace the lens cap.
Attach the lens cap according to the following procedures.
Pass the string through a hole of the lens cap.
Turn over the projector and remove the screw with a
screwdriver.
Attaching the Lens Cap
Attach the string with lens cap to a hole at the bottom of
the projector and secure it with a screw.
1
2
3
Lens Cap
String for the lens cap
Secure it to the hole
with a screw.
Hole
cAutIoN
Do not use any flammable solvents or air sprays
on the projector and in its vicinity. The explosion
or fire hazard may occur even after the AC power
cord is unplugged because the temperature inside
the projector is extremely high due to the lamps. In
addition, there is a risk that the internal parts may
be damaged not only by the flammable air spray but
also by the cold air.