Sanyo PLC-WL2500A, Owner'S Manual

Page: 45 / 78

45
Auto setup
Input search
This function detects the input signal automatically. When
a signal is found, the search will stop. Use the Point
▲▼
buttons to select one of the following options.
Off ......... Input search does not work.
On 1 ....... Input search works under the following situation.
– When pressing the AUTO SET button on the
remote control.
On 2 ....... Input search works under the following situation.
– When turning on the projector by pressing the
ON/STAND-BY button.
– When pressing the AUTO SET button on the
remote control.
– When the current input signal is cut off.*
* If the No show or Freeze function is active, cancel
it to activate the Input search. It is also unavailable
when On-Screen Menu is displayed.
Auto PC adj .
On . . . . . . .Enables Auto PC adjustment when pressing
the AUTO SET button on the remote control.
Off . . . . . .Disables Auto PC adjustment.
Auto setup
 Note:
• While Input search function is set to
On 1
or
On 2
, the status of Input and Lamp are displayed every time the
signal is switched.
• Only the last selected input source can be detected.
• If the COMPUTER 1/2 button, VIDEO, S-VIDEO, COMPONENT or HDMI button on the remote control is
pressed during Input search is in progress, Input search will stop and go back to the previous input signal.
• Auto PC adj. and Input search functions can not be set
Off
at the same time.
•
Fine sync
,
Total dots
,
Horizontal
and
Vertical
positions of some computers can not be fully adjusted
with the Auto PC adjustment function. When the image is not provided properly with this operation, manual
adjustments are required (pp.31-32).
This function enables Input search and Auto PC adjustment by
pressing the AUTO SET button on the remote control. Settings
for those functions can be altered as follows:
Setting