Sanyo PDG-DHT8000L - 8000 Lumens, Service Manual

Page: 13 / 242

-13-
Check the number of lamp to be replaced on the Lamp
Status Display.
Loosen a screw on the Lamp Cover. Slide and open
the Lamp Cover until it makes a clicking sound. (See
the right figure.)
1
3
Loosen two screws and pull out the Lamp to be re-
placed by grasping handle.
4
Turn off the projector, press the Main On/Off Switch to
Off and unplug the AC power cord from the AC outlet.
Let the projector cool for at least 45 minutes.
2
Replace the Lamp with a new one and tighten two
screws. Make sure the Lamp is set properly.
6
Follow these steps to replace the lamp.
Put the Lamp Cover back and tighten a screw.
5
SCREW
LAMP
COVER
Make sure which number of lamp needs to be
replaced on Lamp Status Display.
Figure shows case of replacing LAMP 1.
LAMP 2
NoteS oN LAMP rePLAceMeNt
To maintain quality of picture (better balance of color and brightness in entire screen), we recommend replacing both
2 lamps at a time.
Lamp Replacement
For continued safety, replace with a lamp assembly of
the same type.
Do not drop the lamp assembly or touch a glass bulb!
The glass can shatter and may cause injury.
Allow the projector to cool, for at least 45 minutes be-
fore you open Lamp Cover. The inside of the projec-
tor can become very hot.
cAutIoN
TURN OFF THE UV LAMP BEFORE OPEN-
ING THE LAMP COVER.
WArNING:
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen
and LAMP 1/2 REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing when the
LAMP 1/2 REPLACE indicators should light is depending on the lamp mode.
Indicators
Lamp replacement icon
✔
Note:
• The Lamp replacement icon will not appear when the
Display function is set to “Off”, or during “Freeze”.
Maintenance
LAMP 1
SCREWS
ORDER REPLACEMENT LAMP
Replacement Lamp Type No. : POA-LMP145
Service Parts No.
: 610 350 6814
POWER
LAMP
WARNING TEMP.
WARNING FILTER
SHUTTER
LAMP 1 REPLACE
LAMP 2 REPLACE
LAMP 1 / 2 REPLACE indicators