Sanyo PDG-DHT100L - DLP Projector - HD 1080p, Owner'S Manual

Page: 58 / 92

58
Chapter 5 Controlling the Multi-Projectors
Exclude/Add/Delete a projector
To change the mode of the registered pro-
jectors, Select a mode with the pull-down
menu button under the IP address of the
target projector and then press the
Set
button.
Status
If some of the registered projectors are
deactivated by some reasons (such as dis-
connecting the power source, disconnect-
ing the LAN cable, disconnecting from the
network), control changes will continue to
be effective for the projectors that are still
activated. At the same time, the deactivat-
ed projectors are excluded from the multi-
control. The status of the registered pro-
jectors are indicated under the projector
name. See the table below for status indi-
cations.
Mode Operation
OFF : Exclude from the multi-control
ON : Add to the multi-control
Delete : Delete from the multi-control
Status Description
(blank) ................The projector is connected to the network correctly
No connected ........The projector may not be connected to the network. Please check the connection
and network configuration of this projector.
Password error ......The login password is incorrect. The password for the multi-controlled projectors
must be the same. Change password of this projector to the common password.
✐
If the multi-controlled projector is in the standby mode, any change is not effective except
timer setting.
✐
It is recommended that a specified projector should be chosen for setting when you use this
multi-control function. The control for the multi-controlled projectors will become too compli-
cated operation if this function is used for each projector.
✐
If the registered projector is not connected to the network, it will take some time to complete
the multi-control operation because the network board is waiting for the response from each
registered projector.