1
FOR SAFE AND EFFICIENT OPERATION
-
Do not damage the mains lead.
When not in use, disconnect the mains lead from the outlet. Grasp the plug. Not the mains lead,
when disconnecting the unit.
-
If water should enter the unit, electrical shock or a malfunction may result. Use in an area where
there is low humidity and little dust.
-
Do not disassemble or alter the unit in any way.
-
Do not use the unit in areas where extremes in temperature occur (below 0
O
C or exceeding 35
O
C),
or where it may be exposed to direct sunlight.
-
Because of the CD player’s extremely low noise and wide dynamic range; there is a tendency to
turn the volume on the amplifier higher than necessary. Doing so may product an excessively high
output from the amplifier, which can cause damage to your speakers. Please be careful in this
regard.
-
Sudden changes in the surrounding temperature can cause dew to from on the optical pickup lens
inside the unit. Under this condition the unit may be unable to operate properly.
If this should occur, remove the disc and allow the player to adjust to the surrounding temperature.
-
This unit must be operated in a horizontal position.
-
Please use the original CD software, and any copy discs are not recommendable for use.
- The apparatus shall not be exposed to dripping or splashing.
Do not install the equipment in a confined space, such as a bookcase or built-in cabinet.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT PROPERLY
QUALIFIED SERVICE PERSONNEL.
CAUTION:
THIS PRODUCT CONTAINS A LOW POWER LASER DEVICE, TO ENSURE
CONTINUED SAFETY DO NOT REMOVE ANY COVERS OR ATTEMPT TO
GAIN ACCESS TO INSIDE OF THE PRODUCT.
REFER ALL SERVICING TO QUALIFIED PERSONNEL.
5
6
CLA SS 1 L ASER P RODUCT
LA SER KLA SS E 1
A PPARE IL A LA SE R D E CLA SS E 1
LUOK AN 1 LA SE RLA ITE
K LASS 1 LA SE RAP PARAT
Rating plate
2
POWER SUPPLY
AC power operation
Connect one end of the mains lead to the (AC ~
IN) socket and the other end to an AC outlet.
The unit is not disconnected from the mains
unless the mains lead is unplugged from the AC
outlet.
Battery power operation
1. Open the battery compartment lid by
pushing down on the tabs.
2.
Install 8 x “C” size batteries (not supplied).
Refer to the polarity diagram in the battery
compartment of the unit. Match the marks
of (+) and (-) on the diagram to the marks of
(+) and (-) on the batteries.
8 x “C” size batteries
3.
Replace the lid.
BATTERY PRECAUTIONS
Follow these precautions when using
batteries in this device:
1. Use only the size and type of batteries
specified.
2. Be sure to follow the correct polarity when
installing the batteries as indicated in the
battery compartment. Reversed batteries
may cause damage to the device.
3. Do not mix different types of batteries
together (e.g. Alkaline and Carbon-Zinc)
or old batteries with fresh ones.
4. If the device is not to be used for a long
period of time, remove the batteries to
prevent damage or injury from possible
battery leakage.
5. Do not try to recharge batteries, which
are not intended to be recharged; they
can overheat and rupture. (Follow battery
manufacturer’s directions.)
