11
MAINTENANCE
Cleaning the unit
Clean the outside of the unit with a clean soft
cloth, moistened with lukewarm water. Do not
use solvents such as benzene or thinner. These
will permanently damage the unit’s finish.
Cleaning the CD player lens
The lens should never be touched.
If dust is on the lens, blow it off using a camera
lens blower. (Please consult your dealer.)
If trouble occurs…
To avoid the hazard of electric shock and
damage to the unit, have the unit bench tested
by an authorized SANYO service station. Do not
remove the unit from its cabinet to attempt
repairs yourself.
Warning
-
Do not block the ventilation hole.
-
Do not expose to rain or moisture.
Cleaning the tape heads
When dust or reddish-brown oxide builds up on
the tape deck heads, pinch roller and capstan,
the following problems may result:
Poor sound quality during playback
Distorted, poor quality recordings
Erratic tape speed during recording or playback
To ensure playback and recording with good
quality sound, use a cleaning tape (available
from your local audio dealer) to clean the head
block of the deck after about every 10 hours of
use.
OR
1. Open the cassette compartment lid by
pressing (STOP/EJECT).
2.
Moisten a cotton bud with isopropyl alcohol
or special head cleaning fluid. Gently rub
the face of play/record head and erase
head. Also clean the capstan and pinch
roller.
TROUBLESHOOTING GUIDE
Should this unit exhibit a problem, check the following before seeking
service.
Symptom Possible
cause Solution
Radio
Station not tuned properly for AM
or FM
Return the AM or FM broadcast
station.
FM: Rod antenna is not
extended.
Extend FM rod antenna.
Noise or sound distorted on AM or
FM broadcasts.
AM: Unit is not positioned
correctly.
Rotate unit until best reception is
obtained.
FM STEREO indicator does not
light
BAND Selector is set at FM
position.
Set BAND Selector to
FM STEREO position.
Function Selector is not at RADIO
mode.
Set Function selector to RADIO.
AM or FM, no sound
Volume at minimum
Increase Volume.
12
Cassette Player
Function selector is not at TAPE
mode
Set Function selector to TAPE.
No sound
Volume at minimum
Increase Volume
Sound distorted.
Dirty head.
Clean the head.
Tape old or worn.
Replace the tape.
Speed varies
Dirty roller and capstan.
Clean roller and capstan.
Cassette Recorder
Will not record.
Record protection tab removed.
Cover hole with tape.
Distorted sound on playback.
Defective tape or dirty tape head. Replace tape or clean tape head.
Compact Disc Player
Function Selector is not at CD
mode.
Set Function Selector to CD.
CD Player will not play.
CD is not installed or installed
incorrectly.
Insert CD with label side facing
up.
CD skips while playing.
Disc is dirty or scratched.
Wipe disc with cloth or use
another disc.
Disc inserted upside down.
Insert disc properly.
Disc is dirty.
Clean disc.
Disc is inserted but CD player
skips over spot and will not play.
Disc is non-standard.
Use correct disc.
SPECIFICATIONS
(Cassette Section)
Playback:
4 tracks stereo
Recording:
DC bias/Magnet erase
Tape Speed:
4.75cm/sec.
Fast forward and
Rewind time:
Approx 170 sec.
(C-60
tape)
(CD Section)
Channels
: 2 channels
S/N ratio
: 60dB
Wow & Flutter
: Undetectable
Sampling frequency : 44.1KHz
Quantization
: 16 bits linear/ch
Pick up light source : Semi-conductor laser
(Radio Section)
Tuning ranges: FM: 87.5-108 MHz
AM: 525-1650 kHz
Aerial:
Built-in ferrite bar (AM)
telescopic rod aerial (FM)
(General)
Power output:
24 Watts (P.M.P.O.)
Frequency response: 80-10,000Hz
Speaker impedance:
8 ohms
Headphone impedance: 8-32 ohms
Power source: AC 230-240V 50Hz
DC 12V (8 x “C” size batteries)
Power consumption: 12 Watts
Dimensions: 305(W) x 220(D) x 150(H) mm
Weight: 2 kg (not including batteries)
Specifications are subject to change without notice.
Printed
in
China
172-401PCD784-SY
