Sanyo KA-PN04, Owner'S Manual

Page: 42 / 56

42
Serial Port Use
If you forgot the password or address, you can check it or write a new one it to communi-
cate to the Network board by using a serial port (RS232C).
Service Setting
To enter the Service Mode
1
Turn the monitor on.
2
Press and hold the Position Up (
e
) button
on the monitor and press the Status but-
ton on the remote control unit to appear
the Dealer Mode Menu.
4
– +
VOLUME INPUT MENU
OK
Position Up (
e
) Button
Status Button
Front key lock 0
0
0
0
0
0
0
Input
Max volume
On Screen Display
MENU
Initial setup
Remote control
Dealer Mode Menu
Dealer Mode Menu
3
Disconnect and connect the output cable
of the Network Board. The Network Board
begins entering the service mode and it
takes about 1 minute.
To exit the Service Mode
Disconnect and connect the AC plug from
the monitor.