15
Two beeps are heard. The setting is saved and the UPS returns
to normal operation.
§
§
3
3
.
.
1
1
2
2
S
S
e
e
t
t
t
t
i
i
n
n
g
g
L
L
o
o
w
w
B
B
a
a
t
t
t
t
e
e
r
r
y
y
V
V
o
o
l
l
t
t
a
a
g
g
e
e
W
W
a
a
r
r
n
n
i
i
n
n
g
g
T
T
i
i
m
m
i
i
n
n
g
g
When using the supplied power management software or optional power management software, you cannot
set this menu on the control panel of the UPS. Set this menu using the power management software. Refer to
the
User Guide
of the power management software.
①
Check that the UPS is in the following condition.
②
Press and hold
for 3 or 4 seconds. Then release it when two beeps are heard.
③
Quickly press
(within 3 seconds) several times to set the 5 LEDs surrounded by in the figure
below to a blinking pattern such as the one in the figure.
④
Quickly press
(within 3 seconds) several times to switch to the setting value LED blinking pattern
to select for the 4 LEDs surrounded by
in the figure below.
⑤
Press and hold
for 3 or 4 seconds.
Then release it when two beeps are heard.
LEDs that blink when the “3 minutes” setting is selected.
Setting
Setting LED
Description
Battery
voltage
●
○
○
○
Warning is emitted (Alarm buzzer
sounds and BATT.LOW lights) when
low battery voltage level is detected.
2 minutes
○
●
○
○
Warning is emitted when remaining
battery duration is 2 minutes.
3 minutes
●
●
○
○
Warning is emitted when remaining
battery duration is 3 minutes.
The buzzer does not sound when “OFF” or “Pattern 2” is selected as the
setting value in §3.8 “Setting Buzzer Sound”.
If you are using the power management software, the above setting is
disabled and the warning is emitted at the timing set for performing
UPS shutdown in the power management software.
The blinking pattern changes each time you press
or
.
If you miss the LED blinking pattern you want to select, continue pressing
the button repeatedly until the LED blinking pattern is redisplayed.
Tip
Default
setting
When using the power management
software, the LEDs may blink as shown
in the left figure. You cannot set on the control
panel of the UPS. Change the setting using
the power management software.
Set the timing of emitting the low
battery voltage warning.
MAIN SW on the back panel set to “ON”. *1
The “Green ON/STAND BY” and
the “Green OUTPUT are not blinking. *2
*1. Operation is possible regardless of whether
is ON or OFF.
*2. If these LEDs are blinking, Forced Bypass switch
may be set to “Bypass”. Set this switch to “Inverter”,
and restart the UPS.
Tip
The UPS switches to the user setting mode.
Buzzer sounds : 2 beeps
：
Either BATT.LOW or 25
blinks,
or both
BATT.LOW and 25
blink.
：
INPUT blinks.
：
LED is off.
：
LED is blinking.
Press
Press
Hold for 3 or 4 sec.
until 2 beeps.
Hold for 3 or 4 sec.
until 2 beeps.