Sanus VisionMount VMF220, Instruction Manual

Page: 9 / 40

6901-002023 07
9
2 Mount the Wall P late
Solid concrete or concrete block
2-1 Mark the wall
2-2 Drill pilot holes
2-3 Insert anchors and lag bolts
10 mm
(3/8 in.)
CAU T I O N:
Avoid potential injuries or property damage!

Pilot holes MUS T be drilled to a depth of 89 mm (3½ in.) using a
10 mm (3/8 in.) diameter drill bit.

Never drill into the mortar between blocks.
Insert lag bolt anchors [24] . Then insert lag bolts [17] through the
washer [16] , wall plate [03], and into the anchors.
CAU T I O N:
Improper use could reduce the holding power of
the lag bolt. To avoid potential injuries or property damage:

Be sure the anchors [24]
are seated flush with the
concrete surface.

Tighten the lag bolts [17]
only until the washers
[16] are pulled firmly
against the wall plate [03] .

D O N OT over-tighten the lag
bolts [17] .
For assistance in determining wall plate location,
see Height Finder at sanus.com.
Level the wall
plate [03] and mark the hole locations.
CAU T I O N:
Avoid potential injuries or
property damage!

Mount the wall plate [03] directly onto the
concrete surface.

Minimum solid concrete thickness: 203mm
(8 in.).

Minimum concrete block size: 203 x 203 x
406 mm (8 x
8 x 16 in.).
Level the wall plate [03] and mark the hole
locations.
IM PO R T AN T : TV will shift 82.5 mm (3¼ in.) to
the right when in the home position. Consider this
when selecting the location of your wall mount.
[03]
[03]
13 mm
(1/2 in.)
82.5 mm
3¼ in.
[24]
[17]
[16]
89 mm
(3½ in.)