Step 2: Attach Universal Projector Interface to Projector
Loosen, but do not remove the Acorn Nuts shown in Diagram 2A.
Place the Universal Projector Interface (
A
) on the projector, aligning the holes in the Adjustable Feet with the threaded holes
in the projector and with the Threaded Suds in line as shown in Diagram 2A. If there are only three mounting points, remove
one Leg from the Universal projector Interface by removing the Acorn Nut.
uds in line as shown in Diagram 2A. If there are only three mounting points, remove one Leg from the Universal projector
Interface by removing the Acorn Nut.
If necessary, add Extension Arms (
B
) to the Universal Projector Interface (
A
) by removing the Adjustable feet and Installing
them on the Extension Arms as shown in Diagram 2B.
Secure the Extension Arms (
B
) to the Universal Projector Interface, using the M6 x 8 mm (
S
) screws as shown in
Diagram 2B.
Adjust the Adjustable Feet as shown in Diagram 2C, making sure to allow for proper air ventilation and keeping the Universal
Projector Interface level with the projector. Some Adjustable Feet may need to be at different heights.
NOTE:
If the mounting holes are closer than a five inch diameter, lower the feet all the way to allow the Threaded Stud
to swing under the Ceiling Plate (C)
.
Determine the proper screw size and depth, M3 x 10 mm (
O
), M4 x 12 mm (
P
), M5 x 12 mm (
Q
), or M6 x 12 mm (
R
), and
corresponding Washers (
L
,
M
) for projector mounting.
Using correct Screws (
O,P,Q,R
) and Washers (
L,M
), secure the back two legs of the Universal Projector Interface (
A
) to the
projector; then, secure the front legs.
Move the Universal Projector Interface (
A
) to the center of gravity of the projector. You can locate the center of gravity by
attempting to lift the projector straight up. If it feels like it wants to twist, move the Universal Projector Interface toward the
heavy side. When the projector feels balanced, you have located the center of gravity.
Threaded
Studs
Acorn
Nut
Acorn
Nut
Adjustable
Foot
Hex Nut
on all
Adjustable Feet
Adjustable
Foot
Diagram 2C
Install
M6 x 8 mm
Screw (S)
Remove
Adjustable Foot
and install here
Rotate Adjustable Foot left or
right to increase or decrease
length. Each rotation equals
0.625” [15.80 mm].
Hex Nut
on all
Adjustable Feet
