13
Structure of the machine
Sabrina Foam is made by the following parts:
Machine body,
Accessory to spray foam, complete with its solution pipe for the connection to the
machine body,
Vacuum plastic hand tool and vacuum hose for the connection to the machine body.
The machine body contains all the necessary devices for spraying foam and then vacuuming
it:
The air compressor and the compressed air tank, located in the lower part,
The lower tank, containing the water and chemical solution used to clean,
The upper tank, used to recovery the dirt sucked with the vacuum motor,
The solution pump and the vacuum motor, situated inside the lower tank,
The control panel for the pump and for the motor,
The control panel for the compressor and for the regulation of foam.
Preparation for work
To prepare the machine for work, do the following operations:
1. Insert the male quick disconnect coupling (located at the end of the solution pipe coming
out from the foam regulation panel) into the female quick disconnect coupling (located at
the pump outlet). In this way you allow the solution sprayed by the pump to enter inside
the lower part, where the foam is generated.
2. Check that the valve at the foam outlet is closed. Connect the solution pipe of the spray
accessory to the foam outlet and then open the foam outlet valve.
