58
5.1.7
Change the Pan/Tilt setting
Click the
Pan/Tilt
button on the home page to open the Speed Dome Controller.
1.
Click
“
Configure
”
to enter to the RS485 setting page (please refer to
Change the System
Setting
—
RS485 Setting
).
2.
Select a Speed Dome device ID from the drop-down list on the Speed Dome Controller. The
Controller will display the corresponding ID.
3.
Each of the ten buttons under
‘
Set
’
is connected with a specific position and angle of either
panning or tilting of the camera. Click each button to activate its particular position and
angle. Press the button under
‘
Preset
‘
to turn the camera angle by angle in the set positions.
Each of the ten buttons designated
‘
Go to
’
can be clicked to view the particular
corresponding angle of the position in which it is set.
4.
Select the connecting port. The RS-485 communication ports function as connectors when
two or more units are serially connected to an external control device.
5.
Upon the buttons being clicked, a camera will move one short step only in any of the four
designated directions.
6.
Click the buttons to control the Focus setting on the Speed Dome Controller. Click
“
+
”
button to focus far and click the
“
–
“
button to focus near.
7.
Click the buttons to control the Zoom setting on the Speed Dome Controller. Click
“
+
”
button
to zoom in and click the
“
–
“
button to zoom out.
8.
Upon the buttons being clicked, a camera will turn all the way, without stopping, in one of
the four designated directions.
9.
Click the buttons to control the Aperture setting on the Speed Dome Controller.
