-
6 -
STEP BY STEP OPERATION GUIDE FOR TREATMENT
Preparing the Skin for Running a Session
Proper preparation of the skin covered by the electrodes allows more stimulation to reach targeted tissues, prolongs
electrode life, and reduces the risk of skin irritation. After connecting the lead wire(s) to the stimulator, use the following
steps to prepare your skin at the electrode placement sites:
1. Determine the placement sites for the electrodes.
2. Wash the area with mild soap and water (do not use alcohol). Rinse and dry thoroughly.
3. Trim excess body hair from the area with scissors (do not shave).
4. Optionally, apply skin prep to the area to form a protective barrier on your skin. Apply, let dry, and apply electrode as
directed. This will both reduce the chance of skin irritation and extend the life of your electrodes.
5. When removing electrodes, always remove by pulling in the direction of hair growth.
6. It may be helpful to apply skin lotion on electrode placement area when not wearing electrodes.
Inserting/Changing the Batteries
1. Open the battery compartment at the back of the device by pushing the battery cover labelled “Open” downward (this
area features raised marks for easy identification).
2. Insert 3 AAA (1.5 V) batteries in the battery compartment; make sure to match up the symbols (+/–).
3. Close the battery cover by carefully placing the stud into the slot in the rear area and sliding it upward, applying slight
pressure.
4. Follow the same procedure when replacing the battery at a later date.
ġ
ˏ
ˏ
Note
: for important precautions regarding the batteries ,please be informed:
x
Always use only 3x1.5V (AAA) batteries.
x
Keep away from children.
x
Do not recharge.
x
Do not short-circuit.
x
Do not throw into a fire.
x
Please recycle. Do not dispose of old batteries with your household waste; dispose of them safely at your
recycling centre or business where the batteries were purchased.
NOTE: the batteries should last between 30 and 60 application depending on stimulation times and frequencies.
