- 16 -
3.3
Quick install
It is easy to use “Quick install” to create a volume. It uses whole physical disks to create a RG; the system
will calculate maximum spaces on RAID levels 0/1/3/5/6/0+1. “Quick install” will occupy all residual RG
space for one VD, and it has no space for snapshot and spare. If snapshot is needed, please create
volumes by manual, and refer to section 4.4 for more detail. If some physical disks are used in other RGs,
“Quick install” can not be run because the operation is valid only when all physical disks in this system are
free.
Step 1: Click “Quick install”, then choose the RAID level. After choosing the RAID level, then click
“
”. It will link to another page.
Figure 3.3.1
Step 2: Confirm page. Click “
” if all setups are correct. Then a VD will be
created.
Done. You can start to use the system now.
Figure 3.3.2
(Figure 3.3.2: A RAID 0 Virtual disk with the VD name “QUICK16150”, named by system itself, with the
total available volume size 271GB.)
