SANLI MT426, Manual

Page: 11 / 20

Starting your multi tool.
Before operating your multi tool, mix 40 parts of regular unleaded petrol to 1 part
2- stroke oil (40:1). Do not overfill the tank as this can risk fuel spilling on hot components when
in use. It is recommended that you make your mixture with a fuel mixing bottle
Slide the ignition switch, away from the
STOP position
(Fig 18).
Fig 18
Press the primer bulb three or four times
until a flow of fuel is visible inside the fuel
line
(Fig 19).
Set choke lever into closed position, if
starting from cold
(Fig 20).
Pull the starter cord until the multi
tool starts (or makes a false start),
then return choke to the open
position
.
Re-attempt to start and after it starts, allow
the engine to warm up for at least 20 to 30
seconds. For warm restarts, do not prime,
just pull the cord and it will start after one or
two pulls.
Fig 19
Fig 20