SANLI MT426, Manual

Page: 15 / 20

Basic maintenance made easy.
1. Spark plug.
Wait until the engine has cooled before disconnecting the spark plug located under the rubber
cover and then removing the spark plug with the box spanner supplied. If it is dirty, you can clean
the plug with a wire brush.
The applicable spark plug for this machine is the NGK BPMR7A. For optimum results we advise you
to replace the spark plug after 20 hours of use.
When refitting the spark plug take care not to over-tighten.If adjusting yourself,note that the spark
plug gap must be set initially to 0.6 but after the machine has been used for some time,
regulate the gap to 0.7 mm.
2. Air filter.
Fig 19
Ensure that the engine is cool,remove the air filter cover and then take out the air filter
element, see ( F i g 1 9), Put the cover back on the housing immediately to prevent any
objects falling into the air intake.
Carefully brush off any excess dirt particles, or clean filter element using lukewarm soapy water.
When cleaning with water, rinse thoroughly and allow to dry before replacing air filter element.
3. Storing petrol & oil.
WARNING! Petrol is highly flammable so extreme caution must be taken. Always store
petrol in approved containers and ensure petrol is less than 30 days old.
WARNING! If the multi tool is not serviced correctly, you could void warranty and reduce
its ability to operate effectively.