SEC3002 FIRE ALARM CONTROL PANEL
Page 10 of 24
EVAC
Gives an evacuation warning by activating all sounders of
the system at access level 2&3
F.P.E. DIS/EN
Disables or re-enables the F.P.E. Out at access level 2&3
SILENCE/RESOUND
Silences the system’s sounders at access level 2&3. Press
again to resound the sounders previously silenced
MUTE
Silences the panel’s internal buzzer
RESET
Returns the panel to its normal condition by clearing all
fire and fault status indications at access level 2&3
F1, F2
Reserved buttons
4.3 Zone indication and control panel
The panel offers 32 control buttons with a pair of indicator LEDs beside each button. After
registering with default settings, the upper LED of a pair lights when a zone goes into fire. The
lower LED indicates fault or disablement/test status of that zone (it flashes when there is any
fault with the zone, it lights steadily when the zone is in disablement or test condition). The
control button then is used to activate sounders in that zone.
Note:
Each unit of LEDs with a button corresponds to a zone by default settings. Besides, it can be
defined to control a field device and give indication by configuring at Access Level 3 (refer to the ZCP
setup function at section 5.2.3). In this case, the button is to start or stop the device and the upper
LED lit to indicate a start command. It is strongly suggested that a label with a zone number or device
name be stuck at the left of LEDs as a clarification of that unit.
5. Commissioning and Programming
5.1 Overview
Commissioning is the setting to work of the panel after completion of all the installation and
connection work. It includes registering and test of detectors and modules, setup of the zone
indication and control panel, C&E programming and etc. All these functions are only available
at access level 3, which are detailed by the following introduction.