Sanitas B5P, Instructions For Use Manual

Page: 14 / 40

14
Safety system
NOTE: the heated underblanket is equipped
with a safety system. The electronic sensor
technology prevents the entire surface of the
heated underblanket from overheating by
automatically switching off in the event of a
fault. If the safety system switches the hea-
ted underblanket off automatically as a re-
sult of a fault, the temperature display on the
control 1 will no longer be illuminated when
the heated underblanket is switched on.
Please note that the heated underblan-
ket must not be used after a fault for
safety reasons and must be returned to
the service address indicated.
Use
Positioning the heated
underblanket
Beginning at the foot end, spread the
heated underblanket fl at over the
mattress.
Cover it with a sheet in the usual way
so that the heated underblanket is bet-
ween the mattress and the sheet.
Make sure that the heated underblanket
is spread out completely fl at and cannot
become bunched up or creased during
use.
Switch the heated underblanket on
approx. 30 minutes before you go to
bed and cover it with the top cover. This
prevents the heat from escaping.
Switching on / off / selecting the
temperature
Before using the heated underblanket,
connect the control 1 to the heated
underblanket using the plug-in connec-
tor 2 (see Fig. B).
Switching on:
Set Level 1, 2 or 3 on the control 1 to
switch the heated underblanket on.
Switching off:
Set Level 0 on the control 1 to switch
the heated underblanket off .
Selecting the temperature:
Set the highest temperature level
( Level 3) fi rst. This heats up fastest.
If you wish to leave the heated under-
blanket on for several hours, set the
lowest temperature level (Level 1).
Temperature levels
Set the required temperature level on
the control 1 (see Fig. A).
Level 0: off
Level 1: minimum heat
Level 2: medium heat
Level 3: maximum heat
Cleaning and care
WARNING ! DANGER TO LIFE
FROM ELECTRIC SHOCK!
Before cleaning the heated under blanket,
always remove the mains plug from
the socket and disconnect the plug-in
connector 2 together with the control 1
from the heated underblanket (see Fig. B).
RISK OF ELECTRIC SHOCK! Do not
reconnect the control 1 to the heated
underblanket until the connector 2 and
the heated underblanket are completely
dry. There is otherwise a risk of an elec-
tric shock.
RISK OF ELECTRIC SHOCK! RISK OF
MATERIAL DAMAGE!
Do not under any circumstances switch
the heated underblanket on for drying.
Use a dry, non-fl uffi ng cloth for cleaning
and care of the heated underblanket and
the control 1 .
Safety system / Use / Cleaning and care
GB