3
HOW TO ASSEMBLE
CAUTION: Completely assemble vacuum cleaner before
using.
Assembly Packet is with ownerʼs guide.
A
2-Part
Bolt
B
Lower
Cord Hook
C
Bag
Screws
Step 1
Attach the Handle
Push lower handle into handle socket on the base.
NOTE: Check to be sure slot in handle is positioned
correctly, see Detail A.
Align the holes on the lower handle and the socket. Insert
a 2-part bolt (A) in the bottom center of the handle and
tighten.
Push upper handle onto lower handle. Make sure grip curves
away from cleaner.
Align the holes on the upper handle
to the holes on the lower handle. Insert a 2-part bolt (A)
in center of the handle and tighten.
1
1
001 ASSEMBLED
Step 2
Attach Lower Cord Hook
Make sure cord hook is pointing downwards. Press the power
cord into the groove on the cord hook pulling any slack toward
the base of the cleaner. On the cord hook, fi nd the curved
tab and place in slot on lower handle section, keep cord taut
while pressing the cord hook to the left until it snaps into slot
on opposite side of handle. The hook should point downward
on the same side that the cord exits the hood.
Step 3
Attach Outer Bag
IMPORTANT: To provide a good gasket seal, the bag
coupling must seat firmly against the
motor base.
Hold outer bag with zipper away from the handle. Line up
screw holes. Start the bag screws by hand, then tighten with
a screwdriver.
Loop the bag spring onto the bag support hook located at the
back of the upper handle section.
Step 4
Store Electrical Cord
The cleaner has two convenient cord storage hooks attached
to the handle. However, some models feature a quick release
cord hook on the upper handle. A downward twist of the cord
hook frees the cord for quick removal. With either style, wind
the cord around the hooks for storage. Fasten the plug to the
cord to prevent unwinding.
2
3
3
4
4
2
