12
How to change the dust bag
• Lift up cover latch release and pull off cover
(Fig.1).
• Grasp the clamp on both sides and squeeze to
release the full dust bag (Fig. 2).
• Align new dust bag collar with slots in bag holder
(Fig. 3). Slide bag back into position until it clicks.
• Align tabs at bottom of dust bag cover with slots
(Fig. 4). Press top of cover back toward cleaner
body. Press cover latch down.
Note:
Dust bag cover will not latch without a dust
bag installed.
Pre-motor filter
The pre-motor filter is located under the dust bag.
Check this filter each time the dust bag is changed.
• Clean or replace as needed. Shake filter to remove
excess dust. If necessary, wash with water and
mild detergent.
• Reinstall filter after completely dry.
How to replace the HEPA filter assembly
• Step on handle release pedal and lay cleaner flat
for easy access to filter cover.
• Press tab to release HEPA filter cover and lift
cover off.
• Grasp tab and lift out filter.
• Install new HEPA filter.
• Match tabs with slots and press HEPA filter cover
back into place.
Note:
Some filters are washable and can be
cleaned by rinsing with warm water. Be sure the
filters are completely dry before installing.
ENGLISH
www.sanitairecommercial.com
How to maintain
the vacuum cleaner
CAUTION
Turn off the switch and unplug the
electrical cord before maintenance.
!
1
3
4
2
